TomT
Last activity:
May 18, 2012 at 5:47 AM
Joined:
Apr 7, 2010
Messages:
604
Likes Received:
29
Trophy Points:
9

Followers 4

  1. timber
  2. DonMcJr
  3. fabianewart
  4. Jorge
Gender:
Male
Location:
Conneaut,Ohio 1 mile south of Lake Erie, 1 mile
Occupation:
Electrical Tech when I was in the Air Force

Share This Page

TomT

Male, from Conneaut,Ohio 1 mile south of Lake Erie, 1 mile

I have never had a controller like this. Ask Windy Guru as this is Josh at Windy Nation. He has experience with this type controller. Jan 18, 2012

TomT was last seen:
May 18, 2012 at 5:47 AM
    1. fabianewart
      hey it me again i see a 500 watt misouri basic turbine it's a dc output if i get this can i just hook this up to a xantrex c40 without any dump resister.
      Mar 9, 2012
    2. TomT
      I have never had a controller like this. Ask Windy Guru as this is Josh at Windy Nation. He has experience with this type controller.
      Jan 18, 2012
    3. fabianewart
      So i get this controller but it charge pretty fast on the first setup the heat sink was doing it job it was hot, but the next day until today it never heated up again and my battery charging ratio is very slow any help.
      Jan 17, 2012
    4. fabianewart
      My Xantrex C60 charge every slow am using a 210 watt evergreen solar panel with 2 (6)volt 220 amp battery . before i get this controller i was charging fine but i was afraid that i will damage the battery (continue in next post)
      Jan 17, 2012
    5. fabianewart
      Can the Xantrax C60 charge controller Control the charge into a battery bank from a wind generator and solar panels at the same time
      Jan 15, 2012
      2. TomT
        TomT
        I think Josh already did a post on this. This is a solar only controller. Solar thru the charge controller and wind thru a rectifier. Straight from there to the battery. If it over charges the controller will go to dump.
        Jan 15, 2012
  • Loading...
  • Loading...

  • Signature

    Effsun 300 Watt PMA -with modified 5 blade and nose cone
    WN 500 Watt PMA - WN 5 Blade
    10.8 - 30 volt 120 Volt SunG Wind GTI
    22-60 volt SunG 500 Watt 120 volt Wind GTI - Battery Tied 24v - 10,000 MFD on DC Line
    Heavy Duty switched dump at 28 volts
    240 Watts Solar - 12v - Porch Roof Fixed Mount
    CPT-1000W Grid Tie

    About

    Gender:
    Male
    Location:
    Conneaut,Ohio 1 mile south of Lake Erie, 1 mile
    Occupation:
    Electrical Tech when I was in the Air Force
    Motorcycles,Computers and Wind,Solar Energy
    New at the third one but learning fast.

    Interact

    Content: