805-323-6445 | info@windynation.com

clean|power to the people

This product qualifies for FREE SHIPPING
1/2 inch Arbor for Wind Turbine Generator Blades and Hub
out of stock
0.3 lbs
  • Brand: Windy Nation Inc.
  • Product Type: 1/2 inch Arbor
  • Model: ANH-ARBR-12
  • UPC: 609728675738
  • MPN: ANH-ARBR-12
  • Energy Type: Wind

This is a new arbor for wind generators which will allow you to attach your hub and blades to the shaft of your wind generator. It is machined on a computer-controlled lathe to exact tolerances using 304 stainless steel. This will attach to any motor/generator shaft that is 1/2-inch in diameter.

Corrosion Protection!

This arbor will not rust. Every component on a wind generator should be weather resistant, so don't settle for arbors made from improper materials.

  • 1/2 inch diameter arbor. The arbor will fit any motor or generator shaft that is 1/2 inch in diameter. The threaded portion of the arbor is 1/2- inch diameter and threaded at 13 TPI (threads per inch). This means you can attach a hub that has a 1/2 inch diameter mounting hole.
  • A stainless steel nut + stainless steel lock washer. This allows you to securely attach a hub to the arbor.
  • Three stainless steel set screws which allow you to securely attach the arbor to the shaft of the motor or generator. Three set screws spaced 120 degrees apart allow for a perfectly balanced arbor. This keeps your rotor spinning smooth and balanced even at very high RPMs.